Buffalo Technology AirStation Pro WLA-AWCG - Manual (Page 11)

Getting Started 8
WLA-AWCG User Manual
„
WLA-AWCG User Manual
„
Warranty Card
„
Antenna connector
2.2.2 Software requirements
The AirStation Pro requires the following software to operate:
„
Windows 95/98/ME, NT or 2000
„
Internet Explorer 4.0 or higher, or Netscape Navigator 4.0 or higher
Internet Explorer is installed as standard on Windows 98 and Windows 2000.
„
AirStation Manager software
„
Client Manager software (if you have a Wireless Client)
The AirStation Manager and Client Manager software is provided on the AirStation
Series Driver CD. For instructions on installing the software see:
„
“Installing the AirStation Manager Software” on page 33
„
Refer to the WLI-PCM-L11 Wireless LAN card User Manual.
Initial setup
To connect all the hardware supplied with the AirStation Pro pack and set up the
system, follow these steps.
1 Connect the AirStation Pro to a power supply, using the AC/DC power
adapter.
Do not use any adapter other than that which is supplied with the AirStation
Pro.
The AirStation Pro power light will display green.
2 Connect one end of the straight-through cable to the AirStation Pro LAN port.
3 Connect the cable to the PC/Hub.
The procedure for this step differs, depending on whether you are connecting
the AirStation Pro directly to a PC or to a hub.
Connecting directly to a PC
Connect the other end of the cross-over cable directly to your PC.