JLG M4069 ANSI Service Manual - Manual (Page 10)

SECTION 1 - SPECIFICATIONS
1-2 – JLG Lift – 3121122
1.2 CAPACITIES
1.3 PRESSURE SETTINGS
1.4 COMPONENT DATA
Battery Charger
Input 220 VAC, 50 HZ Input, (110 VAC,60 HZ)
Output, 48 VDC @ 23 Amp
Batteries
6 Volt, 370 Amp-hour - Quantity (8) - MAC Charger
JLG MACHINES EQUIPPED WITH DELTA Q BATTERY CHARGERS
ARE DESIGNED FOR THE BEST PERFORMANCE WITH OEM FAC-
TORY APPROVED BATTERIES.
APPROVED JLG REPLACEMENT BATTERIES ARE AVAILABLE
THROUGH JLG' S AFTERMARKET PARTS DISTRIBUTION CEN-
TERS OR JLG' S AFTERMARKET PROGRAMS. FOR ASSISTANCE
WITH PROPER BATTERY REPLACEMENT, PLEASE CONTACT
YOUR LOCAL JLG SUPPORT OFFICE.
BATTERIES APPROVED BY JLG HAVE BEEN TESTED FOR COM-
PATIBILITY WITH THE ALGORITHM PROGRAMMING OF THE
DELTA Q BATTERY CHARGER TO OPTIMIZE BATTERY LIFE AND
MACHINE CYCLE TIMES. THE USE OF NON APPROVED BATTER-
IES IN YOUR JLG EQUIPMENT MAY RESULT IN PERFORMANCE
ISSUES OR BATTERY CHARGER FAULT CODES. JLG ASSUMES
NO RESPONSIBILITY FOR SERVICE OR PERFORMANCE ISSUES
ARISING FROM THE USE OF NON APPROVED BATTERIES.
Drive System
Drive Motor - 48 VDC, 11.8 H.P. peak 5.5 H.P. continuous,
rotation - reversible
Drive Brake - 24 VDC, spring-applied, hydraulically
released
Steer System
Tires - IN240/55-17.5 FF
IN240/55-17.5 FF non marking
27.2/10.5LL-15.0 FF TURF - SLR - 4020 lb.@42 PSI
Toe-In - 1/4 inch (6.4 mm) overall
Hydraulic Pump/Electric Motor Assembly
Pump Output - 3.86 gpm (14.6 lpm) @ 2175 psi (150 bar)
1.5 TORQUE SPECIFICATIONS
NOTE: When maintenance becomes necessary or a fas-
tener has loosened, refer to Section 1.12, Torque
Charts to determine proper torque value.
Table 1-2. Capacities
Description 3369LE/M3369 4069LE/M4069
Hydraulic Tank
8.25 gal (31.2 liters)
5.4 gal (20.4 liters) @ full mark
Hydraulic System approx. 8.5 gal (32.1 liters)
Torque Hubs (2) 17 ounces (0.5 liters)
Table 1-3. Pressure Settings
Description 3369LE/M3369 4069LE/M4069
Main Relief (±50 psi)
3000 psi
(207 bar)
Steer Relief
2500 psi
(172 bar)
Lift Relief
2600 psi
(179 bar)
2800 psi
(193 bar)
Table 1-4. Torque Specifications
DESCRIPTION
TORQUE VALUE
(DRY)
INTERVAL HOURS
Torque Hub
240 ft lbs
(336 Nm)
500
Wheel Nuts
170 ft lbs
(238 Nm)
50
Fixed Axle Bolts
220 ft lbs
(308 Nm)
500
Drive Motor
35 ft lbs
(49 Nm)
N/A
Pump Motor
Terminals
12-14 ft lbs
(14-19 Nm)
N/A