Eppendorf Multipette Xstream - Manual (Page 19)

19
Installation
Multipette ® /Repeater ® (X)stream
English (EN)
4 Installation
4.1 Mains/power supply device assembly

Insert the power plug adapter required for your mains/power supply into the opening
of the mains/power supply device. If there is any doubt as to which power plug adapter
should be used for the power supply unit, you should consult an electrician.
4.2 Inserting the Li-ion rechargeable battery
1 Power plug adapters
a EU
b United Kingdom
c USA
d Australia
2 Mains/power supply device
3 Charging plug
Abb. 4-1:Insert the Li-ion rechargeable battery
Fig. 4-1: Insert the Li-ion rechargeable
battery
1 Connector socket
2 Plug
3 Li-ion rechargeable battery
Insert the rechargeable battery as
follows:
1. Take off the lid of the rechargeable
battery compartment.
2. Insert the Li-ion battery. Do not remove
the foam insert in the rechargeable
battery compartment.
3. Connect the plug of the Li-ion
rechargeable battery to the connector
socket.
4. Replace the rechargeable battery
compartment lid.
3