Advance Adapters 48-6400 - Manual (Page 9)

ADVANCE ADAPTERS INC. P/N: SUZUKI
P.O. Box 247, 4320 Aerotech Center Way New Item: (09/09)
Paso Robles, CA 93447 PAGE 9 OF 11
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 09-09-09
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
SUZUKI GEARS KIT NUMBERS
48-4160 / 48-4900 /48-6400
38. Install the O-ring on the cluster pin and slide the bearings and spacer on the cluster pin.
39. Apply grease to the cluster bearings and slide the cluster gear onto the shaft assembly. Take the cluster assembly
having the pin flush with the large end of the gear and slide it into position in the case. Then push the pin from
the small end of the cluster to capture the thrust washer and to index into the case.
40. Slide the input gear assembly into place.
41. Apply grease into the rear housing and to the other thrust washer assembly,
holding the washer in place.