Advance adapters inc. p/n: suzuki – Advance Adapters 48-6400 User Manual
Page 5

ADVANCE ADAPTERS INC.
P/N: SUZUKI
P.O. Box 247, 4320 Aerotech Center Way
New Item: (09/09)
Paso Robles, CA 93447
PAGE 5 OF 11
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
09-09-09
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
SUZUKI GEARS KIT NUMBERS
48-4160 / 48-4900 /48-6400
25. Clean the caged needle bearing that was under this gear and re-install on to the shaft with some bearing grease.
Now install the new low speed gear on to the shaft. Install the gear spacer, the speedometer gear, bearing and
bearing collar. The speedometer gear and bearing are a press fit.
26. Flip the shaft back over and re-install the shifter slider and the high speed needle bearing onto the shaft. Use bearing
grease on the needle bearing and then install the new high speed gear.
27. Re-install the gear spacer and press the bearing back in place. The spur gear and snap ring can then be re-installed.