Advance Adapters AB1001 - Manual (Page 8)

ADVANCE ADAPTERS, INC.
4320 Aerotech Center Way, Paso Robles, CA 93446
ASSEMBLY INSTRUCTION SHEET
Page 8 of 12 Rev. Date: 06-18-08 P/N AB1000 & AB1001
ATLAS 2 SPEED REBUILD KITS
You'll need to install the caged needle bearing back onto the new output shaft along with the high range gear. A new
spacer has been included in the kit which fits between the high range gear and the new tapered roller bearing. You
can now install the new front retainer over the shaft assembly. Install the new seal washer and the new front yoke
with the nut. Torque the nut to 150 ft./lbs. We have also included a new o-ring for the aluminum housing, and this
should also be installed now.
Assembly reminder:
Hold the output shaft in your hand. You want to have the three notches over
you thumb and fore finger. Slip the slider over the shaft and drop in the three
synchro dogs. Roll the spring onto the two of the dogs and then snap it into
the third and flip shaft over and repeat this step.