Advance adapters, inc, Atlas 2 speed rebuild kits – Advance Adapters AB1001 User Manual
Page 11
Helpful hints for installing the Atlas cluster gear:
Grease the back sides of the thrust washers and set the
washers into the case, ensuring that the tabs of the thrust
washers fit the slots of the Atlas case. The grease help
hold the thrust washers in place while the cluster is in-
stalled.
Install the cluster pin on one side just enough to hold
one on the thrust washers in place. Slip your finger into
the cluster pin hole on the opposite side to retain the
other washer in place. If the washer falls down you will
have to remover the gear and repeat the process. Many
times the washer will fall half way down and prevent
the cluster pin from going in.
After you succeed in the installation, do a visual check
from the access pan to verify that the washers are in
place.
ADVANCE ADAPTERS, INC.
4320 Aerotech Center Way, Paso Robles, CA 93446
ASSEMBLY INSTRUCTION SHEET
Page 11 of 12 Rev. Date:
06-18-08
P/N AB1000 & AB1001
ATLAS 2 SPEED REBUILD KITS