Advance Adapters AB1001 - Manual (Page 10)

ADVANCE ADAPTERS, INC.
4320 Aerotech Center Way, Paso Robles, CA 93446
ASSEMBLY INSTRUCTION SHEET
Page 10 of 12 Rev. Date: 06-18-08 P/N AB1000 & AB1001
ATLAS 2 SPEED REBUILD KITS
Use Loctite 518 to reseal the shifter control to the Atlas case. Insert the shift rails into the back side of the case and
guide them through the shift forks inside the Atlas. Once installed, bolt the shifter control into position with the three
bolts and torque to 25 ft./lbs.
Align the shifter set screw hole on the shifter fork with the matching hole on the shift rod. Install the set screw with
Loctite 242 and torque to 15 ft./lbs.
Install the cluster gear, thrust bearings, and cluster pin. Two new o-rings have been provided for the cluster pin. Be
careful to make sure that the thrust washers are properly aligned between the inside of the case and cluster gear.
Install the two cluster pin bolts and seal washers to retain the cluster pin in its proper location. Torque these bolts to
16 ft./lbs
.
Install the new pan gasket and inspection cover. Torque (14) bolts to 10 ft./lbs.
Replace the drain plug, fill with oil, and reinstall the unit back into the vehicle.