beautypg.com

Advance adapters, inc, Atlas 2 speed rebuild kits – Advance Adapters AB1001 User Manual

Page 3

background image

ADVANCE ADAPTERS, INC.

4320 Aerotech Center Way, Paso Robles, CA 93446

ASSEMBLY INSTRUCTION SHEET

Page 3 of 12 Rev. Date:

06-18-08

P/N AB1000 & AB1001

ATLAS 2 SPEED REBUILD KITS

Using a plastic dead blow hammer, use one hand to support the Atlas shift forks inside the case to prevent binding
on the shift rails and the other hand on the hammer, lightly tapping the shift rails from the front of the case. This
provides an easy way of pulling the shifter control from the Atlas case. Once the shift control is removed, clean
both the case and shifter control mating surfaces.

Remove the forks from the case. (Note: If you have Atlas case
#1929 or earlier and have not upgraded your shifter forks, this is an
ideal time to install new shift forks,

P/N 301550

).

Remove the 5 bolts from the front output shaft retainer and the 4 rear bearing cap bolts. Remove the front assembly
from the Atlas case.

Note:

The low range gear, bearing, spacer, and rear bearing will be left in the case.

Remove the front yoke nut and front retainer. Remove the bearing and spacer. The gear and needle bearing can
then be removed.

This manual is related to the following products: