Snorkel SB80 - Manual (Page 9)

9
BY TRUCK OR TRAILER
1. Insure that boom is fully lowered and retracted.
2. Maneuver the machine onto bed of truck / trailer.
3. When winching, follow instructions for emergency
towing on page 6. Attach winch cable to front tie
down lugs.
Do not winch machine faster than 5 km/h
(3 mph).
4. After winching, insure that all four drive hubs are
engaged by returning the center caps to their
original orientation.
5. Install swing lock pin.
6. Secure the machine to the transport vehicle using
chains / straps of adequate load capacity (refer to
specifications, back page) attached to chassis tie
down lugs. (See Figures 8 and 10).
7. Place wooden block 10 x 20 x 91 cm (4" x 8" x 36")
under platform support braces as shown (Figure 9).
8. Attach straps or chains to cage hold down brackets.
Do not over tighten.
NEVER elevate the machine while on a truck or
trailer.
Figure 10: Rear chassis tie down lifting lugs.
Figure 9: Securing the machine for transportation.
Figure 8: Front chassis tie down lifting lugs.
Chassis Tie Down
Lifting Lugs
Platform Tie Down Strap
Wooden Block
4" x 8" x 36"
(10 x 20 x 91 cm)
Support Braces
Chassis Tie Down
Lifting Lugs