Operation manual, System overview – Class1 118253 - ITL40 108404-XX - Full User Manual
Page 5
![background image](/manuals/546776/5/background.png)
FORM-ENG-0018 REV A 05-27-03
PAGE
4 of 25
S U I T A B L E F O R E X T E R N A L D I S T R I B U T I O N
OPERATION MANUAL
DATE
9/24/2008
PRODUCT GROUP
ITL40
P/N
118404-XX
REV
1.00
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473
PRODUCT
Intelli-Tank Level 40
BY
AMS
MANUAL
P/N:118253
P
RINTED
:
1/8/09
2. System
Overview
2.1. Scope
The Intelli-Tank Level 40 (ITL40) is designed to display a liquid’s volume to an eighth of a tank level accuracy through
180-degree viewable ultra-bright LEDs. An Intelli-Tank Level 40 set as a MASTER uses a 0-5 PSI (0-34.47 kPa,
0-0.3447 bar) pressure sensor to obtain tank level information and then relays that information along the
communication line(s) (1-Wire or CAN) to ITL40’s set as REMOTES. Multiple REMOTE units can be linked to the
MASTER tank level.
2.2. Part
numbers
Tank Level Gauge
C1 – p/n 118404-01 – Red LEDs
p/n
118404-02
–
Amber LEDs
p/n 118404-03 – Yellow LEDs
p/n
118404-04
–
Green LEDs
p/n
118404-05
–
Blue LEDs
p/n 118404-06 – 2 Red, 2 Yellow, 2 Blue, 2 Green rows of LEDs
Labels
C1 – p/n 117691
– water (blue)
p/n 117692
– foam (red)
p/n 117693
– foam (green)
Pressure Sensor
C1 – p/n 102162
– 0 to 5 PSI (0 to 34.47 kPa, 0 to 0.3447 bar) gage
Adapter bushing
C1 – p/n 102219
– ¾ to ¼ NPT
Installation Harness
C1 – p/n 118485-10 – Master display, 10 feet
p/n
118485-20
–
Master display, 20 feet
p/n
118485-30
–
Master display, 30 feet
p/n
118485-40
–
Master display, 40 feet
p/n 118695
– Remote display
Terminating resistor (CAN) C1 – p/n DT06-3S-P006
“Y” connector (CAN)
C1 – p/n DT04-3P-P007
Operation Manual
C1 – p/n 118253
One Page Manual
C1 – p/n 118252
2.3. Modes of Operation
Master
When the ITL40 display is calibrated with a proper pressure signal it automatically becomes a MASTER
display and will send tank level information along the communication line(s) (either 1-wire or CAN) to all
other REMOTE displays.
Remote
ITL40 displays are initially shipped as REMOTE displays. A REMOTE display only requires power,
ground and communications line(s) (either 1-wire or CAN). The REMOTE display mimics the MASTER
display’s LEDs by reading the appropriate information on the communication line(s).