Class1 117155 - TPG Governor - 117684 EXTERNAL - Manual (Page 15)

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473
TECHNICAL DATA SHEET
PAGE
14 OF 26
DATE 3/28/2012
PRODUCT GROUP THROTTLE CONTROL P/N 117155 REV 1.23
PRODUCT TOTAL PRESSURE GOVERNOR (TPG) BY AMS
Manual P/N 117684
Menu items in menu levels 1, 2, and 3
MENU ITEM DESCRIPTION DEFAULT MENU LEVEL
UNITS Configures units of measure PSI / ºF 1
PRESET RPM
Configures the throttle mode (RPM) preset (900 – 1400)
(Not available with message type ANLG)
1000 1*
HI-IDLE
Configures the high idle RPM preset (900-1400)
(Not available with message type ANLG)
1100 1*
PRESET PSI Configures the pressure mode (PSI) preset (90 – 130) 90 1
BRIGHT Configures the display’s brightness level (1-15) 15 1
DISPLAY TEST Tests all of the pixels of the main display N/A 1
ROUND PSI Configures the rounding of the pressure value N 1
ALERT TONE
Alert tones are indicated by a double chirp of the alarm output and
do not indicate alarm conditions. Enable/disable the alert tones.
Y 2
SENSITIVITY Configures the pressure sensitivity window (4 – 12) +/- 6 PSI 2
-SENSOR CAL- Calibrates the zero point of the pressure sensor 142 COUNTS 2
1ST MODE
Configures the first mode active when the MODE switch is pressed
(interlocks permitting)
PSI 2
AUTO MODE
Configures if governor automatically enters into psi mode upon
pump engagement.
(Only available when 1 st mode menu item is set to PSI and menu level was 3 or greater)
NO 3*
COMM STATUS Allows viewing of CAN messages per second and received errors N/A 2
CONTROL Configure control mode and message for engine CFPG (Cummins) 3
RPM IDLE
Configure / adjust the idle rpm
(Not available with message type ANLG)
700 3*
RPM MAX
Configure / adjust the maximum rpm commanded by governor
(Not available with message type ANLG or CFPG)
2200 3*
SOURCE ID
Configure the CAN source ID for the TPG
(only available with message type PGN0 or SCAN)
7 3*
TSC1 RAMP
Configure the RPM ramp speed of TSC1/PGN0 control mode
(only available with message type PGN0)
0 3*
DISPLAY Configure primary display while in pressure mode (rpm or pressure) RPM 3
PSI TIME-OUT
Configures the amount of seconds the TPG will wait after pressure
has dropped below 30 PSI before dropping to IDLE mode
5 3
ALLOW PRESET Configure enable/disable rpm preset if pump is under pressure NO 3
WARNINGS
Configures source of the panel warning LED’s (data bus or user
defined)
Bus 3
WARN ° F
Configure the yellow (warning) engine temp setpoint
(only available when WARNINGS is set to Usr)
- 3*
CRIT ° F
Configure the red (critical) engine temp setpoint
(only available when WARNINGS is set to Usr)
- 3*
WARN PSI
Configure the yellow (warning) oil pressure setpoint
(only available when WARNINGS is set to Usr)
- 3*
CRIT PSI
Configure the red (critical) oil pressure setpoint
(only available when WARNINGS is set to Usr)
- 3*