AEM Infinity Supported Applications - Universal V8 Engine - Manual (Page 45)

Universal 8 45
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Ref.
7100-XXXX-62
7101-XXXX-63
Function
Hardware Specification Notes
C2-51 Coil 7 Coil 7 25 mA max source current
0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal.
C2-52 Coil 8 Coil 8 25 mA max source current
0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal.
C2-53 Coil 9* Coil 9 25 mA max source current
0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal. *Pin not populated in 30-
3805 Univ ersal V8 Base harness.
C2-54 Coil 10* Coil 10 25 mA max source current
0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal. *Pin not populated in 30-
3805 Univ ersal V8 Base harness.
C2-55
Highside Fuel Pump
Switch*
Fuel Pump
Highside switch, 0.7A max, Solid State
Relay , NO internal f ly back diode.
+12V High Side Driv e. Will prime f or 2
seconds at key on and activ ate if RPM >
0. *Pin not populated in 30-3805 Univ ersal
V8 Base harness.
C2-56 Not used Not used Not used Not used
AEM Infinity Pin Numbering
View ed From Wire Side