AEM Infinity Supported Applications - Honda 2001-2005 K-Series Engine - Manual (Page 16)

16
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest. Pin
Honda K
Hardware Specification Notes
C2-49 UEGO 2 HEAT UEGO 2 HEAT
Lowside switch f or UEGO heater
control. Connect to pin 4 of Bosch
UEGO sensor. NOTE that pin 3 of the
Sensor is heater (+) and must be power
by a f used/switched 12V supply .
C2-50 +12V_R8C_CPU
Battery Perm
Power
Dedicated power management
CPU
Optional f ull time battery power. MUST
be powered bef ore the ignition switch
input is triggered. (See C1-65.)
C2-51 Coil 7 Coil 7 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-52 Coil 8 Coil 8 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-53 Coil 9 Coil 9 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-54 Coil 10 Coil 10 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-55
Highside Fuel Pump
switch
Fuel Pump
Highside switch, 0.7A max, Solid
State Relay , NO internal f ly back
diode. +12V High Side Driv e. Will prime f or 2
seconds at key on and activ ate if RPM
> 0.
C2-56 Not used Not used Not used Not used
Honda Pin Numbering
2001–2005 Honda K Series ECU Connectors View ed from Wire Side