AEM Infinity Supported Applications - Honda 2001-2005 K-Series Engine - Manual (Page 13)

Infinity Supported Application 13
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest. Pin
Honda K
Hardware Specification Notes
C2-14 Analog_In_19 DBW_APP2 [%] 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
C2-15 Analog_In_Temp_4
Charge Out
Temperature
12 bit A/D, 2.49K pullup to 5V
See ChargeOutTemp [C] table f or
calibration data and ChargeOutTemp
[C] f or channel data.
C2-16 Analog_In_Temp_5
Airbox
Temperature
12 bit A/D, 2.49K pullup to 5V
See AirboxTemp [C] table f or calibration
data and AirboxTemp [C] f or channel
data.
C2-17 Analog_In_Temp_6
Fuel
Temperature
12 bit A/D, 2.49K pullup to 5V
See FuelTemp [C] table f or calibration
data and FuelTemp [C] f or channel
data.
C2-18 Analog_In_13 Oil Pressure 12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
See Setup Wizard Oil Pressure page f or
setup options. See OilPressure [psig]
f or channel data.
C2-19 Analog_In_14
Traction Control
Mode /
Sensitiv ity
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
See the TC_SlipTrgtTrim [MPH] 1-axis
table. A multi-position rotary switch
such as AEM P/N 30-2056 is
recommended.
C2-20 Analog_In_15
Exhaust Back
Pressure
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
See Setup Wizard Exhaust Pressure
page f or setup options. See EBPress
[kPa] f or channel data.
C2-21 Analog_In_16
DBW1_TPSB
[%]
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
C2-22 +5V_Out_2 +5V Out
Regulated, f used +5V supply f or
sensor power
Analog sensor power
C2-23 +5V_Out_2 +5V Out
Regulated, f used +5V supply f or
sensor power
Analog sensor power
C2-24 +5V_Out_2 +5V Out
Regulated, f used +5V supply f or
sensor power
Analog sensor power