AEM Infinity Supported Applications - Dodge 2008-2010 Viper 4G - Manual (Page 17)

Infinity Supported Application 17
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
08–10 Dodge
Viper Function
08–10
Dodge
Viper Pin
Destination
Hardware Specification Notes
C2-20 Analog_In_15
Exhaust Back
Pressure
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
See Setup Wizard Exhaust Pressure
page f or setup options. See EBPress
[kPa] f or channel data.
C2-21 Analog_In_16
DBW1_TPSB
[%]
C2-33
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the ECU.
C2-22 +5V_Out_2 +5V Out
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-23 +5V_Out_2 +5V Out
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-24 +5V_Out_2 +5V Out
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-25 VR+_In_5
Driv en Right
Wheel Speed
Sensor + Dif f erential Variable
Reluctance Zero Cross
Detection
See Driv en Wheel Speed Calibration in
the Setup Wizard Input Function
Assignment page.
C2-26 VR-_In_5
Driv en Right
Wheel Speed
Sensor -
C2-27 VR-_In_4
Non Driv en
Right Wheel
Speed Sensor - Dif f erential Variable
Reluctance Zero Cross
Detection
See Non Driv en Wheel Speed
Calibration in the Setup Wizard Input
Function Assignment page.
C2-28 V R+_In_4
Non Driv en
Right Wheel
Speed Sensor +
C2-29 LowsideSwitch_9 Tachometer
Lowside switch, 4A max
with internal f ly back diode,
2.2K 12V pullup. Inductiv e
load should NOT hav e f ull
time power.
See Setup Wizard page Tacho f or
conf iguration options.
C2-30 AGND_2 Sensor Ground
C2-15 / C2-
30 / C2-34
Dedicated analog ground Analog 0–5V sensor ground
C2-31 AGND_2 Sensor Ground C2-20 Dedicated analog ground Analog 0–5V sensor ground
C2-32 AGND_2 Sensor Ground
C3-35 / C3-
25 / C3-3
Dedicated analog ground Analog 0–5V sensor ground