AEM 30-6053 Series 2 Plug & Play EMS - Manual (Page 6)

Page 6 of 21
d)
Remove the clip that is hidden underneath the rubber sealing trim next to the
dashboard and the clip for the plastic cover over the stock ECU using a plastic pry
tool to avoid scratching the paint and plastic cover.
Remove clip Remove clip
e)
Remove the carpeting that runs along the lower driver’s side door sill to place the
wiring harness provided. Next, remove the two screws holding the plastic cover
behind the driver’s seat to place the EMS in the area behind the seat.
Remove carpet covering harness Remove screw holding plastic cover
f)
Tap pin 3 on the red/blue TPS wire on the stock wiring harness using the provided
wire-tap. It is located on the white 6-pin connector near the stock ECU shown
below.
Tap pin 3 (red/blue wire) on 6-pin connector