OR-Fab 85208 JEEP JK WRANGLER SWING AWAY SPARE TIRE CARRIER - NON CANISTER - Manual (Page 8)

Swing-Away Tire/Can Carrier 8 Kit 85207 & 85208
c. From top side inside of body enlarge hole to 3/8”
drill and install kit bolt (3/8” x 1”) with hardware
and tighten.
15. Reinstall quarter panel inner foam liner and tail lights
16. Tire mounting.
a. Install kit lock bar on kit tire carrier with two kit
bolts (5/16” x 1”) and two kit flange nuts (5/16”).
b. Position and install tire and wheel assembly on
kit tire carrier with kit urethane spacer, kit alu-
minum plate, and kit T-bar.
17. Kit bump-stop.
a. Install the kit lower bump-stop on the kit tire
carrier.
b. Use the location of the kit lower bump-stop on
the tire carrier to position the kit 2” x 2” stain-
less steel stick pad on the tailgate.
c. Tire-can carrier only: Install your gas cans on
tire-can carrier using the bottom lip of the cans
along with two kit threaded rods (3/8 x 8”), kit L-
brackets and kit wing nuts as shown.
WARNING
The load rating for these tire-can/tire carriers is a
MAXIMUM of 200lbs. Please be aware that some tire
and wheel combinations along with gas cans and hi-lift
jacks can exceed this MAXIMUM rating.
CAUTION
In the step below you may need to slightly grind the
face of the kit lower bump-stop so that it will not dent
the tailgate. When adjusted properly the kit lower
bump-stop should just touch the tailgate and the kit 2”
x 2” stainless stick pad.
Drill to 3/8” and
install kit 3/8” x
1” bolt
Kit Lock Bar
Kit Tire
Carrier
Kit Bolts 5/16” x 1”
Kit Flange Nuts 5/16”
NOTE
After installing tire and cans to rack, carrier may seem
to sag at latch end. Set pre-load to rack by adjusting
hinge plate landing bar to landing block is just above
center of landing area. This will set pre-load after
weight is applied and will close properly.
Kit Lower Bump-stop
Kit Tire Carrier
Tailgate
Kit 2” x 2” Stainless
Steel Stick Pad
Kit Threaded Rods 3/8 x 8”,
Kit L-brackets, Kit Wing Nuts 3/8”
Gas Cans