OR-Fab 85208 JEEP JK WRANGLER SWING AWAY SPARE TIRE CARRIER - NON CANISTER - Manual (Page 5)

Swing-Away Tire/Can Carrier 5 Kit 85207 & 85208
d. Align foot of bracket to location shown here and
install kit bolt (1/4” x 1”) with hardware.
e. From underside of body center punch and drill
upper hole into body with 1/8” pilot drill.
f. From top enlarge hole drilling with 3/8” drill and
install kit bolt (3/8” x 1”) and hardware.
g. Tighten all installed hardware in previous steps.
9. Drill and hole saw for landing block.
a. From under-inside of body center punch remain-
ing bracket hole on the rear inner body and drill
a 1/8” pilot hole.
b. With hole drilled to outside of body as your pilot,
use 1” hole saw through only first layer of body.
c. Drill out remaining inner body layer to 1/2”
Use this
hole
Inner Left
Rear Quarter
Panel
Install kit
bolt, 1/4” x 1”
kit landing
block mount
bracket
Pilot Drill
1/8” Hole
kit bolt,
3/8” x 1”
WARNING
Careful to keep drilling straight through as you will drill
two layers of body. An angle drill is highly recom-
mended.
drill 1/8”
hole
Outer body
Drill open to 1”
Drill to 1/2”