OR-Fab 83223 JEEP JK WRANGLER / STUBBY FRONT BUMPER WITH HOOP AND OFFSET WINCH MOUNT - Manual (Page 4)

JK Wrangler HD Winch Bumper 4 Kit #83210/83220/83222/83211/83221/83223
a. Identify kit pass & drvr winch sideplates.
b. Carefully lift up winch and kit winch base plate
and slide sideplate into position. Kit winch
base plate should sit on top of lower lip of kit
sideplate. Loosely secure kit sideplate to OE
frame horn and kit bumper using kit bolt (1/2” x
1-1/2” Button Head) and flange nut.
Kit Pass Winch
Sideplate Kit Drvr Winch
Sideplate
Kit winch base plate
Kit Sideplate
Kit Bolt &
Flange Nut
c. Loosely secure kit winch base plate to kit side-
plate using four kit bolts (1/2” x 1” Hex Bolt) and
flange nuts.
d. Install two kit bolts (1/2” x 1 1/4” Button Head)
and flange nuts through front face of bumper.
Install winch fairlead at this point if using.
e. Tighten all kit hardware installed up to this
point.
7. Note: 2010 & 2011 Models mark and drill
passenger side lower crash bar. Mark and drill
(using a 1/2” drill bit) passenger side lower crash bar
Kit winch base plate
Kit Sideplate
Kit Bolt &
Flange Nut
Kit Winch Bumper
Winch
Kit Bolt &
Flange Nut
Copyright 11/06
Performance Automotive Group
www.p-a-g.net