OR-Fab 83223 JEEP JK WRANGLER / STUBBY FRONT BUMPER WITH HOOP AND OFFSET WINCH MOUNT - Manual (Page 3)

JK Wrangler HD Winch Bumper 3 Kit #83210/83220/83222/83211/83221/83223
hanging sheet metal from lower crash bar so kit
winch bumper may sit flush on crash bar..
** 2012 Model: Will require installion steps & kit 87046
Vacuum Pump Relocation Kit at this point in the install
2. Bolt center winch mount plate to winch if installing.
Triangle shaped tabs face upwards and towards the
front of vehicle, position winch properly. Secure
using hardware supplied with winch.
3. Position winch with kit winch plate bolted to it on
top of OE crash bar between frame rails. Be careful
not to drop, use zip ties or similar device to tempo-
rarily secure if needed.
Mark & Cut
Lower Crash
Bar
Lower Crash
Bar
Winch Plate kit Bolts & Hardware
Winch
kit winch plate & Winch resting between frame
rails
4. Position kit D-Ring hooks into kit bumper.
5. Lift kit winch plate off OE crash bar and position kit
main bumper in position. Loosely secure on each
of the front outer holes with kit bolts (1/2”-1-1/4 But-
tonhead) and Flangenuts.
6. Install kit winch sideplate
NOTE
Pass winch sideplate may be shorter then driver to
allow for clearance on jeeps with sway bar disconnect
system. This change was made at a later date and is
not reflected in the photo below.
Kit Bumper
Kit D-Ring hook plates
Kit Bumper
Kit D-Ring hook plates
Kit Bolt
Kit Bolt