OR-Fab 83205 ROCK SLIDER REAR BUMPER JEEP JK - 2/4 DOOR - Manual (Page 5)

5 Rock Slider Rear Bumper - Kit 83205
d. Repeat on passenger side.
3. Kit Bumper (Plate Upper)
a. Install three kit bolts (3/8” x 1” button head),
three kit washsers (5/16” USS), and kit plate
(bumper, upper) on top of kit bumper (center).
DO NOT TIGHTEN.
b. Install two kit bolts (3/8” x 1” button head), four
kit washers (5/16” USS), and two kit nuts (3/8”
flange).
Kit Bolt (3/8” x 1” button
head) Kit Plate (bumper,
upper)
Kit Bolt (3/8” x 1”
button head)
Kit Plate (bumper,
upper)
Factory Bracket
Kit Nut (3/8” flange)
Kit Washers (5/16
USS)
4. Align kit bumper assembly and tighten all mounting
bolts.
Engine Compartment
1. Connect both battery cables. Connect positive cable
first, then negative cable.
Miscellaneous
1. Check all fasteners to ensure they are tight.
WARNING
Retorque all fasteners after 500 miles and after off road
use. All body lift components should be visually
inspected and fasteners retorqued during routine vehi-
cle servicing.
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications made to
the vehicle and how they affect vehicle handling and
performance. Failure to provide the customer with this
information can result in damage to the vehicle and
severe personal injury.
Positive Cable Negative Cable