OR-Fab 83205 ROCK SLIDER REAR BUMPER JEEP JK - 2/4 DOOR - Manual (Page 2)

2 Rock Slider Rear Bumper - Kit 83205
Before Starting Installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Park vehicle on a clean, dry, flat, level surface and
block tires so vehicle cannot roll in either direction.
Engine Compartment
1. Disconnect both battery cables. Disconnect nega-
tive cable first, then positive cable.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
NOTE
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover
Positive Cable Negative Cable
Rear Bumper
1. Remove Factory Bumper
a. Remove two bolts from brackets on back side of
bumper.
b. Remove two bolts from each bumper bracket at
frame and remove bumper.
c. Hitch Vehicles: Remove four bolts, from frame
cross support.
Bumper
Bolt
Muffler
Bracket
Bumper
Bracket
Bolts at
Frame
Bolts Frame Cross
Support Hitch