OR-Fab 83205 ROCK SLIDER REAR BUMPER JEEP JK - 2/4 DOOR - Manual (Page 3)

3 Rock Slider Rear Bumper - Kit 83205
Prepare to Install Kit
Rear Bumper Assembly
1. Rear Bumper
a. Install kit bumper (driver) to kit bumper (center)
with two kit bolts (7/16” x 1”), two kit washers
(3/8” USS), and two kit nuts (7/16” flange). DO
NOT TIGHTEN BOLTS.
b. Repeat for kit bumper (passenger).
Rear Bumper Install
1. Kit Rear Bumper Plate
Kit Bumper
(driver)
Kit Bolts ( 7/16” x 1”),
Kit Washers (3/8”
USS),
Kit Nuts (7/16”
flange)
Kit Bumper
(center)
a. Non-Hitch Vehicle: Install four kit bolts (7/16” x
4”), four kit washers (3/8” USS), four kit nuts (7/
16 flange), and kit plate (bumper, rear)
b. Hitch Vehicle: Install four kit bolts (7/16” x 4”),
four kit washers (3/8”), and kit plate (bumper,
rear). Install kit bolts from back side of bumper
cross brace into factory weld nuts..
Kit Plate (bumper, rear)
Kit Bolts ( 7/16” x 4”),
Kit Washers (3/8” USS),
Kit Nuts (7/16” flange)
Kit Plate (bumper,
rear) Factory Weld Nuts