OR-Fab 83203 JEEP CHEROKEE XJ 3-PIECE FRONT WINCH BUMPER - Manual (Page 9)

9 ‘84-’01 XJ Front Bumper - Kit 83202, 83203
4. Driver wheel well liner
a. Mark driver wheel well liner as desired and trim.
b. Repeat above step for passenger side wheel
well liner.
5. Driver Support Bracket
a. Install kit bracket (support, driver) onto driver
side unibody and kit bumper with four kit bolts
(1/2” x 1-1/2”), four kit washers (1/2” SAE), and
four kit nuts (1/2’ flange). DO NOT TIGHTEN.
b. Kit# 83202: Repeat above step for kit bracket
(support, passenger). TIGHTEN all hardware.
NOTE
Before installing top bolts, install kit grill guard hoop, if
purchased.
Mark Wheel
Well
Cut Wheel
Well
Kit Bolts
(1/2” x 1-1/2”),
Kit Washers
(1/2” SAE),
Kit Nuts
(1/2” Flange)
Kit Bracket
(Support)
c. Kit# 83203: Repeat above step for kit bracket
(support, passenger). DO NOT TIGHTEN.
6. Kit# 83203: Driver Support Bracket & Winch
Bracket
a. Install kit bracket (winch) onto kit bumper (cen-
ter) with four kit bolts (7/16” x 1”) and four kit
washers (7/16” USS). DO NOT TIGHTEN.
b. Install two kit brackets (support) onto kit
bumper (center) with two kit bolts (1/2” x 1-1/2”)
and two kit washers (1/2” SAE). DO NOT
TIGHTEN.
NOTE
Before installing top bolts, install kit grill guard hoop, if
purchased.
Kit Bolts
(1/2” x 1-1/2”),
Kit Washers
(1/2” SAE),
Kit Nuts
(1/2” Flange)
Kit Bracket
(Support)
Kit Bracket
(Center)
Kit Bolts
(7/16” x 1”),
Kit Washers
(7/16” USS)
Kit Bracket
(Winch)
Kit Bracket
(Support)
Kit Bolt
(1/2” x 1-1/2”),
Kit Washer
(1/2” SAE)
Kit Bumper
(Center)