OR-Fab 83203 JEEP CHEROKEE XJ 3-PIECE FRONT WINCH BUMPER - Manual (Page 8)

8 ‘84-’01 XJ Front Bumper - Kit 83202, 83203
b. Cut fender along marked line.
c. Test fit kit corner (driver) onto kit bumper (cen-
ter).
d. Mark and cut fender flare and fender flare
bracket along marked line for desired fit.
Remove lower valence along with cut portions of
fender flares.
e. Install fender flare and fender flare bracket onto
fender with nut, if possible.
f. Repeat above steps for kit corner (passenger).
Fender
Marked Line
Cut Fender
Kit Bumper
(Driver)
Cut Fender
Flare
Fender Flare
Stud Hole
Cut Fender
Flare Bracket
3. Driver section
a. Remove kit bolt (10mm x 40mm) and kit
washer (10mm) from kit bumper (center) and
unibody.
b. Install kit corner (driver) onto kit bumper (cen-
ter) with four kit bolts (1/2” x 1-1/2”), four kit
washers (1/2” SAE), four kit nuts (1/2” flange),
kit bolt (10mm x 40mm), and kit washer
(10mm). DO NOT TIGHTEN.
c. Repeat above steps for passenger side section.
d. Align and level kit bumper (center) and
TIGHTEN two kit bolts (10mm x 40mm), three
kit bolts (7/16” x 4-1/2”), and two passenger
side kit bolts (1/2” x 1-1/2”).
e. TIGHTEN eight kit bolts (1/2” x 1-1/2”), kit cor-
ner (driver), and kit corner (passenger).
Kit Bolts
(1/2” x 1-1/2”),
Kit Washers
(1/2” SAE),
Kit Nuts
(1/2” Flange)
Kit Bumper
(Driver)
Kit Bumper
(Passenger)
Kit Bumper
(Center)