Fluid Management 22CW Blendorama - Manual (Page 15)

FAST & FLUID MANAGEMENT
PAGE NO. 15 of 27
CW - V1.2 – 10- 05- 2012 (36609) – rev, B
IV OPERATION
V OPERATION
Step 5 Charge the pump
>
With the gauges correctly set,
slowly and gently lift the red
pump handle until both red and
black handles are against the
appropriate gauge knobs Continue to hold this for a few
seconds to ensure the pump
is correctly filled with colorant.
If the colorant level is too low, air can be sucked into the pump. If this occurs,
return the handle to the zero position, add sufficient colorant, and purge the
pumps and valve (see chapter IV, step 2 & 3)
Step 6 Discharge the pump
> >
While still holding the pump
handle in the raised position,
pull the spring-loaded valve
lever (at the base of the pump)
forward its full travel Holding the valve lever fully
forward, press the red handle
down with a smooth and
steady stroke until the red
handle is fully depressed. Ensure that both the red and
black handles are fully
depressed against the end
cap. All the colorant has now
be discharged and the valve
lever can be released
Repeat the charging and
discharging process for each
colorant specified in the formula
If you have to tint more than one
container of the same color, leave the gauges
set at the required reading and simply
recharge and discharge each pump in turn in
the order nominated by the tint formula