Fluid Management 22CW Blendorama - Manual (Page 13)

FAST & FLUID MANAGEMENT
PAGE NO. 13 of 27
CW - V1.2 – 10- 05- 2012 (36609) – rev, B
IV OPERATION
> >
V OPERATION
Step 4 Check the effectiveness of the purge
Repeat this process 10
times. If the drop of colorant
at the nozzle grows
appreciably with each opening
of the valve lever and/or it
drops from the nozzle into the
cup, then air is still in the
system and steps 2 & 3
should be repeated
Open the valve lever without
operating the pump. A small
drop of colorant will appear at
the nozzle
Release the valve lever
slowly and the drop will
withdraw into the nozzle Repeat this process for all
canisters.
Attention! For dispensers fitted with electronic timers, it is important that the
machine be switch on at all times unless topping up canisters.
Attention! For manual agitation type dispensers, it is good practice to agitate
the colorant twice daily for four (4) minutes.
B - General use of the dispenser
Step 1 Select the color, base and can size
A Identify the color you wish to supply either by name or number
B Look up the tint formula and note the Tint Base required
C Identify the quantity required (can size)
Step 2 Position the can
Picture not available
Place the can on the
appropriate can shelf (if
supplied) and adjust the height
of the can shelf if necessary