Fluid Management 53PD Blendorama Installation - Manual

BLENDORAMA SERIES II – V1.1 (36608)-U.S. (10-08-2012) PAGE 1 OF 2
IMPORTANT - READ ME
BEFORE ASSEMBLING THE
DISPENSER!!
Installing the Canisters on 12 & 16 Canister
Turntables.
This information can also be found in the instruction manual.
It is important that the canisters and remote bracket assemblies
are assembled and installed correctly. Please refer to the
information below when installing the canisters on the turntable.
Please note that this procedure is used for all canister sizes, although only
1.75L (22X) canisters are shown here. Other canister assemblies will vary in size and
appearance; however the procedure remains the same. Connecting tubes are
sized specifically for each canister and turntable size – please do not mix
between different models.
Step 1 Prepare and install the inner ring of canisters. (applicable on
25PD & 53PD 16 canister turntables)
A
D
>
C
(1) Select the parts used in an inner
canister assembly:
(A) canister with bush (B) at base
(C) connecting tube
(D) remote bracket and pump
assembly
(E) washer collar self-tapping screw
2) Firmly push the
connecting tube into
the bush. Note: either
end of the tube can be
inserted.
Indication
marks are for internal
use only.