Setting volume amplify, Setting the speaker volume, Setting the ring volume – Brother 580MC User Manual
Page 39: Memory storage, Setting volume amplify -5
I N I T I A L S E T U P
4 - 5
Setting Volume Amplify
Please carefully read “Setting the Handset Volume” before you do the following steps:
1
Press
Function/Set
,
1
,
4
.
2
Press
or
to select VOL
AMPLIFY:OFF? if none of the users are
hearing-impaired and go to Step 4—OR—If
some or all of the users are hearing-impaired,
select VOL AMPLIFY:ON?
3
Press
or
to select PERMANENT? if
all the users are hearing-impaired—OR—
Select TEMPORARY? if only some of the
users are hearing-impaired.
4
Press
Function/Set
.
5
Press
Stop
to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your FAX/MFC is onhook (after you
pressed
Speaker Phone
), by selecting a speaker volume level.
Press
or
to adjust the volume level. The display shows the setting you are
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your FAX/MFC is idle. You can select a ring
volume level or press until the ring is off.
Press
or
to adjust the volume level. With each key press, the FAX/MFC
rings so you can hear the current setting and the display shows the setting you are
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP, SETUP RECEIVE,
SET AUTO DIAL and SETUP MSG CTR plus the COVERPG SETUP and
COVERPAGE MSG (from SETUP SEND) functions are stored permanently. You
may have to reset the date and time.
You can adjust the speaker volume while you are listening to your OGM(Outgoing
Message) and ICMs (incoming messages).
If you turn Incoming Recording Monitor to OFF (
Function/Set
,
8
,
5
), the Speaker
for screening calls will be disabled and you won’t hear callers leaving messages.The
volume for other operations can still be controlled using
and
.
S E L E C T <- -> & S E T
V O L A M P L I F Y : O F F ?
S E L E C T <- -> & S E T
P E R M A N E N T ?