English, Jack, such as, Outputs on the back of the cable box and to the – Philips 50PF9830A-37B User Manual
Page 9: Video (labeled, Labeled, Signal source is selected. • press the, Button to confirm your selection.the
5
English
- Cable box with A/V outputs
• Connect the incoming cable TV signal 1 to a signal splitter (not
supplied).The signal splitter enables you to avoid having to use the
TO TV jack on the back of the cable box.This jack will not supply
stereo sound to the TV.
Note:Your cable box may have a different label for the
TO TV
jack, such
as
OUTPUT
or
OUT
.
• Connect a coaxial cable (not supplied) to a connector on the signal
splitter and to the
CABLE/ANTENNA 75 Ω
x jack 2 on the TV.
• Connect another coaxial cable (not supplied) to a connector on the
signal splitter and to the cable
IN
jack 3 on the back of the cable
box.
• Connect A/V cables (not supplied) to the
VIDEO
and
AUDIO L
and
R
outputs on the back of the cable box and to the
AV2
video
(labeled
VIDEO
) and
AUDIO
(labeled
L
and
R
) jacks 4 on the
back of the TV.
• To view programs from your cable box, first press the
AV+
button
on the remote control.
• Press the cursor down or up buttons until the
AV2
signal source is
selected.
• Press the
OK
button to confirm your selection.The
AV2
input
source becomes current for the viewing of cable TV programs
through your cable box.
Note: If your cable box Audio/Video outputs will not supply video and
stereo audio to the TV, you will need to make the connection shown above
in the example “Cable box with
RF IN/OUT
”.
- Cable box with S-Video, component video (YPbPr) or HDMI
connectors
See Connect Accessory Devices, p. 56-58.
75
L
Pr
H
R
Pb
V
DIGITAL
AUDIO
IN
Y
R
L
Pr
Pb
Y
S-VIDEO
S-VIDEO
AV2
AV3
MONITOR OUT
AV1
VIDEO
G-LINK
DIGITAL
AUDIO
OUT
VIDEO
CABLE / ANTENNA
L
R
VIDEO
SIGNAL
SPLITTER
STB
OUT
IN
3
2
4
CABLE
AV2 :
L + R + VIDEO
1
Watching Cable TV programs that don’t require the cable box
Since you’ve connected the cable TV signal directly to the TV’s tuner, you
can also watch the unscrambled programs by simply tuning to the
desired channel.You must first use Autoprogram, however, to store
channels in the TV’s memory. See page 14.
Note: This connection will supply stereo sound to the TV if it is being broadcast
by the station you are watching.
2496.1 16x24 en 14-12-2005 10:11 Pagina 5