Buhler 535 - Manual (Page 74)

435/485/535
3-45
AD-12
SPEED
PTO RPM AREA
START
STOP
CAL
DIST
% SLIP
DISTANCE
SELECT
AD-11
SPEED
PTO RPM AREA
START
STOP
CAL
DIST
% SLIP
DISTANCE
SELECT
ON
AD-13
SPEED
PTO RPM AREA
START
STOP
METERS
% SLIP
DISTANCE
SELECT
Section 3 - Operation
EIC - Calibration
1
1
2
2
3
9 . As the tractor crosses the “Finish Line” touch the
SELECT button () once . The TPM will display
“DIST CAL 2” .
0 . Touch select button () again to save the
calibration . The TPM will display “DIST CAL 3” .
. Touch start/stop button (2) twice to exit mode 20 .
2 . Drive the tractor around and stop 0 m before the
finish line .
Distance check
. Touch the distance button (3) once . If the TPM does
not display “0 meters or feet” hold the start/stop
button (2) for 2 seconds to clear the display .
2 . Select a low gear and drive the tractor forward .
3 . As the tractor crosses the “Finish Line” touch
the start/stop (2) button once . The TPM will begin
accumulating distance traveled
4 . Continue driving until the tractor reaches the “Start
Line” .
5 . As the tractor crosses the “Start Line” touch
the start/stop (2) button once . The TPM should show
approximately 00 m (+/- 5 m), (328 ft (+/- 5 ft) .
If not, re-run distance check .