Buhler 535 - Manual (Page 28)

435/485/535
2-9
F2-14
F1-6
Section 2 - General Information
Transporting
Transporting the Tractor
. Haul the tractor with all four wheels on to a flatbed
trailer .
2 . Remove the outer duals or triples during
transporting unless special permits allow for over-
width hauling . Consult local authorities for
information on over-width hauling .
3 . Make an accurate measurement of the highest point
on the tractor when it is loaded on the transporter .
Consult local authorities regarding over-height
hauling based on the measurements taken .
4 . Tie-down brackets are located in the following
positions .
Cutout slots () are located on either side of the front
frame to allow a chain hook to be used to hold down
the front end of the tractor .
Tie-down brackets are located on either side of the rear
frame, in the articulation area (2) and on the drawbar
cage (3) . Use a chain of adequate size, routed through
the brackets to hold down the tractor .
1
6 . Always fully engage the park brake and install
the articulation lock pin (4) when transporting the
vehicle .
4
2 3