Buhler 535 - Manual (Page 36)

435/485/535
3-7
F3-5
Section 3 - Operation
Cab Features - Seating
Standard Seat
The seat is equipped with controls to permit the
following adjustments for personal comfort .
NOTE: All adjustments should be made in the following
order while sitting in the seat.
Adjust the seat using the following procedures:
NOTE: With the engine off, adjust the seat by
turning the ignition switch to the “ACC” position.
DO NOT START THE ENGINE.
1. Height/Weight Adjustment
Raise - Depress the top of the switch . Release when
the desired height is obtained .
Lower - Depress the bottom of the switch . Release
when the desired height is achieved .
2. Backrest Angle Adjustment
Lift the lever and tilt the backrest to the desired
position . Release the lever to lock the backrest in
position .
NOTE: The backrest will tilt backward far enough to
contact the rear window.
3. Fore/Aft Position Adjustment
Pull up on the lever and move the seat fore/aft
through the 78 mm (7”) adjustment range to the
desired position . Release the lever to lock the seat
into position .
4. Fore/Aft Float
Pull up on the lever to allow the seat to float fore and
aft 5 mm (2”) . Push down on the lever to lock the
seat into position .
5. Lateral Float
Pull up on the lever to allow the seat to float laterally
5 mm (2”) . Push down on the lever to lock the seat
into position .
6. Storage tray
Pull out for access .
1
2
3
5
4
6