Buhler 535 - Manual (Page 149)

4-6
435/485/535
Section 4 - Lubrication & Maintenance
Every 10 Hours
Operation 12
Lubricate the Front Steering Cylinder Pins
Lubricate the two grease fittings () (one on each side)
until grease flows from around the pin seals .
This will purge any dirt accumulated in the pivot pin
area .
Use Moly base grease (NLGI Lithium, Moly) .
Operation 13
Lubricate the Rear Steering Cylinder Pins
Lubricate the bottom two grease fittings (2) (one on
each side) until grease flows from around the pin
seals . This will purge any dirt accumulated in the
pivot pin area .
Use Moly base grease (NLGI Lithium, Moly) .
Operation 14
Lubricate the Upper Articulation Pin
Lubricate the grease fitting (3) until grease flows from
between the frame pieces . This will purge any dirt
accumulated in the pivot pin area .
Start the unit and articulate from side to side to work
the grease into the joint .
Use Moly base grease (NLGI Lithium, Moly) .
F4-20
1
F4-21
2
F4-22
3