B&K AVR307 - Manual (Page 78)

select Enable or Disabled VOLUME KNOB ˆ
(REW) or
‡
(FF) 2
move to Update ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
RS-232 receive ID -
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 Update Enable
5 Receive ID 0
6 Transmit ID 0
next item SEL select
MENU advanced setup
5 Receive ID 0
5(&(,9( ,'
select desired receive ID VOLUME KNOB
ˆ
(REW) or
‡
(FF) 2
move to Receive ID ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
RS-232 transmit ID -
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 Update Enable
5 Receive ID 0
6 Transmit ID 0
move to new line
next item SEL select
MENU advanced setup
6 Transmit ID 0
75$160,7 ,'
return to MAIN MENU ∠
MENU MENU 5
return to SYSTEM SETUP ∠
MENU MENU 4
return to ADVANCED SYSTEM SETUP
∠
MENU MENU 3
select desired transmit ID VOLUME KNOB ˆ
(REW) or
‡
(FF) 2
move to Transmit ID ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
After completing all of your advanced settings you may wish to backup the settings. Refer to Memory
Backup/Restore under the MAIN MENU or see the Setup section of this manual
FACTORY RESET
Should you ever need to completely reset the receiver to the original factory settings from the front panel press the
SLEEP, DOWN, and MENU buttons simultaneously. The receiver will perform a complete reset and erase all
user programmed presets, menu settings, and the memory backup if you have performed one.
75 p/n 12858 Rev. 0717A