B&K AVR307 - Manual (Page 66)

adjust Zone 1 (A) ID to desired value VOLUME KNOB ˆ
(REW) or
‡
(FF) 2
move to Zone ID ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
Set Zone 1 (A) On Screen display usage - During normal operation, when you make a change to a system
setting or your receiver detects a change to the incoming audio or video, a message is overlaid along the bottom
of your video screen. You can turn off the overlay display from this menu. This will not affect the on-screen
displays when you enter the menu system.
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Display Enabled
4 V1 Output Tape
5 Surround Modes Auto
next item adjust
MENU advanced setup
3 On Sreen Display Enabled
26' (1$%/('
set to Enabled or Disabled VOLUME KNOB
ˆ
(REW) or
‡
(FF) 2
move to On Screen Display ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
Set V1 line output usage - V1 output is normally set up as a tape loop. The V1 and Zone 1 (A) output are the
current source (V2, TV, CD, DVD, etc.) except when the current selection is V1. When V1 is selected as the
source, the Zone 1 (A) output is V1 and the V1 output is off. This prevents feedback when the V1 inputs and
outputs are connected to a tape deck or VCR. Feedback can cause high frequency oscillations which may
damage your speakers. If you don’t connect a tape deck to the V1 input and output you can use the V1 output as
an additional line out. In this mode V1 output is always the selected input including V1. Note: The Tape input and
output is always set up as a tape monitor for Zone 1 (A).
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Display Enabled
4 V1 Output Tape
5 Surround Modes Auto
next item adjust
MENU advanced setup
4 V1 Output Tape
=$ 9 287 7$3(
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Display Enabled
4 V1 Output Line
5 Surround Modes Auto
WARNING Connecting a tape
recorder to V1 in LINE mode
can cause speaker damage
next item adjust
MENU advanced setup
4 V1 Output Line
=$ 9 287 /,1(
set for Tape or Line VOLUME KNOB
ˆ
(REW) or
‡
(FF) 2
move to V1 Output
∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
63 p/n 12858 Rev. 0717A