B&K AVR307 - Manual (Page 38)

Setup variable ‘EQ 1’ - allows you to set default bass and treble settings for use with all input sources. Many
systems allow only adjustment of bass and treble levels at fixed frequency points. Your receiver allows you to
adjust level and frequency to aid in adjusting your room for a flat frequency response. Set bass and treble to the
values you would like have restored into the variable ‘EQ 1’ whenever your unit comes out of sleep (see Select
variable ‘EQ 1’ under OPERATION Equalization).
SETUP ROOM EQUALIZATION
Test Tone 100.0 Hz Off
Notch 100.0 Hz 0.0 dB
Notch Width 97.6 - 102.4 Hz
Bass 100.0 Hz 0.0 dB
Treble 10.0 kHz 0.0 dB
next item adjust
MENU setup system
7(67 +=
100.0 Hz
return to SETUP SYSTEM
∠
MENU MENU 9
set to desired treble level VOLUME KNOB ˆ
(REW) or
‡
(FF) 8
move to Treble Level ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 7
set to desired treble frequency VOLUME KNOB
ˆ
(REW) or
‡
(FF) 6
move to Treble Frequency ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 5
set to desired bass level VOLUME KNOB
ˆ
(REW) or
‡
(FF) 4
move to Bass Level
∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 3
set to desired bass frequency VOLUME KNOB ˆ
(REW) or
‡
(FF) 2
move to Bass Frequency ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
35 p/n 12858 Rev. 0717A