B&K AVR307 - Manual (Page 76)

DSP Usage
Allows displaying the current DSP usage in MIPS.
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
7 RS-232 Control Port
next item SEL select
MENU setup system
6 DSP Usage
DSP USAGE
1 Utilized DSP
Processing Power
XXX MIPS
MENU advanced setup
1 Utilized DSP
Processing Power
XXX MIPS
'63 86$*( ;;; 0,36 )5((
display currently used DSP MIPS ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 3
activate DSP USAGE
↵
(ENTER) SEL or ENTER 2
move to DSP Usage ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
RS-232 Control Port
Configure the advanced computer interface control port on your receiver. For further information concerning
RS-232 operation, see BKC-DIP for the computer interface protocol, and the AVR307 and Reference 30 device
specific appendix's.
RS-232 port setup -
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
7 RS-232 Control Port
next item SEL select
MENU setup system
7 RS-232 Control Port
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 Update Enable
5 Receive ID 0
6 Transmit ID 0
next item SEL select
MENU advanced setup
1 Port Enable
56 3257 3257 (1$%/('
select Enabled or Disabled VOLUME KNOB
ˆ
(REW) or
‡
(FF) 4
move to Port ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 3
activate RS-232 PORT SETUP ↵
(ENTER) SEL or ENTER 2
move to RS-232 Control Port ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
73 p/n 12858 Rev. 0717A