Brady 200M-e 300 - Manual (Page 88)

78 Bradyprinter 200M-e and 200M-e 300 User’s Guide
CANCEL Key Self Test
This self test prints a listing of the
configuration parameters currently
stored in the printer’s memory. See
Figure 31 (depending on the options
ordered, your label may look
different).
1. Turn the printer off.
2. Press and hold the CANCEL key
while turning on the power.
The configuration may be changed
either temporarily (for specific label
formats or ribbon and label stock) or
permanently (by saving the new
parameters in memory). Saving new
parameters occurs whenever a
calibration procedure is performed.
Refer to page 15 for further
information about the configuration
procedure. Additional Power-Up Self
Tests are also performed during the
POST for this test.
Figure 31