Brady 200M-e 300 - Manual (Page 59)

Bradyprinter 200M-e and 200M-e 300 User’s Guide 49
Press Display Shows Action/Explanation
INIT FLASH MEM
Initialize Flash Memory
CAUTION: Perform this operation only when it is necessary to
erase all previously stored information from the
FLASH memory. Press the NEXT/SAVE key to
bypass this function.
1. Press the (+) key to select “YES.”
If your printer is set to require a password, you are now
prompted to enter the password. Enter the password and
then press the NEXT/SAVE key.
2. The display asks “INITIALIZE FLASH?”. Press the (+) key
“YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the (+) key “YES” to begin initialization.
or
Press the (–) key “NO” to cancel the request
and return to the “INITIALIZE FLASH” prompt.
5. Press the SETUP/EXIT key followed by the NEXT/SAVE key.
If initialization is still in process, the front panel display
flashes back and forth between the two phrases
“CHECKING E: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer automatically exits
the configuration mode and the front panel displays “PRINTER
READY.”
NOTE: Depending on the amount of free FLASH memory,
initialization may take up to one minute to complete.