beautypg.com

Removing the label backing material, 5hprylqj wkh /deho %dfnlqj 0dwhuldo – Brady 200M-e 300 User Manual

Page 46

background image

36

Bradyprinter 200M-e and 200M-e 300 User’s Guide

5HPRYLQJ WKH /DEHO %DFNLQJ 0DWHULDO

NOTE: Since the rewind spindle holds the backing from a
standard-size media roll, we recommend that you perform this
procedure whenever you change the media.

To remove the backing material from the rewind spindle, follow these
steps (you don’t need to turn off the printer for this procedure).

1. Unwind approximately 36" (915 mm) of backing from the rewind

spindle. Cut it off at the spindle.

2. Pull out the hook. Slide the backing material off of the rewind spindle

and discard.

3. Wind the media around the rewind spindle once or twice and reinstall

the hook. Continue winding to remove any slack in the media.

Figure 21

This manual is related to the following products: