Cleaning the cutter module, Lubrication, Fuse replacement – Brady 200M-e 300 User Manual
Page 78: Xeulfdwlrq, Xvh 5hsodfhphqw

68
Bradyprinter 200M-e and 200M-e 300 User’s Guide
&OHDQLQJ WKH &XWWHU 0RGXOH
(For printers equipped with the optional cutter.)
If labels are not being cut properly or if the cutter jams with labels, turn off
the printer power and unplug the printer. Then, clean the stationary cutter
blade with cleaning solvent. This removes label adhesive and/or paper
debris. If further cutter cleaning is necessary, or if the cutter continues to
perform unsatisfactorily, contact an authorized service technician.
:$51,1* 7XUQLQJ RII WKH SULQWHU UHVXOWV LQ WKH ORVV
RI ODEHO IRUPDWV LPDJHV DQG DQ\ WHPSRUDULO\ VDYHG
SDUDPHWHU VHWWLQJV VWRUHG LQ WKH SULQWHU·V LQWHUQDO
PHPRU\ 3HUIRUP WKLV SURFHGXUH DIWHU \RXU SULQWLQJ
MRE LV FRPSOHWH
/XEULFDWLRQ
CAUTION: No lubricating agents other than silicon-only
lubricants should be used on the spindle felt clutches of this
printer! Other commercially available lubricants will damage
the finish and mechanical parts if used.
)XVH 5HSODFHPHQW
The fuse in the Brady 200M-e and 200M-e 300 printers is not user
replaceable and must be replaced by a qualified service technician.
Contact Brady for details.