Neff C67M70N3GB User Manual
Neff Mini computers
Table of contents
Document Outline
- [en] Instruction manual
- Table of contents[en] Instruction manual
- : Important safety information
- Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners.
- This appliance is only intended to be fully fitted in a kitchen. Observe the special installation instructions.
- Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport.
- Only a licensed professional may connect appliances without plugs. Damage caused by incorrect connection is not covered under warranty.
- This appliance is intended for domestic use only. The appliance must only be used for the preparation of food and drink. The appliance must be supervised during operation. Only use this appliance indoors.
- Always slide accessories into the cooking compartment correctly. See "Description of accessories in the instruction manual.
- This appliance may be used by children over the age of 8 years old and by persons with reduced physical, sensory or mental capabilities or by persons with a lack of experience or knowledge if they are supervised or are instructed by a person responsi...
- Children must not play with, on, or around the appliance. Children must not clean the appliance or carry out general maintenance unless they are at least 8 years old and are being supervised.
- Keep children below the age of 8 years old at a safe distance from the appliance and power cable.
- Risk of fire!
- ■ Combustible items stored in the cooking compartment may catch fire. Never store combustible items in the cooking compartment. Never open the appliance door if there is smoke inside. Switch off the appliance and unplug it from the mains or switch ...
- Risk of fire!
- Risk of fire!
- Risk of fire!
- Risk of fire!
- Risk of fire!
- Risk of explosion!
- Risk of serious damage to health!
- ■ The surface of the appliance may become damaged if it is not cleaned properly. Microwave energy may escape. Clean the appliance on a regular basis, and remove any food residue immediately. Always keep the cooking compartment, door seal, door and ...
- Risk of serious damage to health!
- Risk of serious damage to health!
- Risk of serious damage to health!
- Risk of electric shock!
- ■ Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker...
- Risk of electric shock and serious injury!
- Risk of electric shock!
- Risk of electric shock!
- Risk of electric shock!
- Risk of electric shock!
- Risk of electric shock!
- Risk of burns!
- Risk of scalding!
- Risk of injury!
- Hazard due to magnetism!
- The retractable control element is magnetic and may affect electronic implants, e.g. heart pacemakers or insulin pumps. For wearers of electronic implants: Do not stand right up against the appliance when you are making settings or cleaning.
- Causes of damage
- Caution!
- ■ Creation of sparks
- ■ Baking tray, greaseproof paper, aluminium foil or ovenware on the cooking compartment floor
- ■ Foil containers
- ■ Water in the hot cooking compartment
- ■ Moist food
- ■ Fruit juice
- ■ Cooling with the appliance door open
- ■ Condensation in the cooking compartment
- ■ Heavily soiled seal
- ■ Using the appliance door for standing on or placing objects on
- ■ Transporting the appliance
- ■ Operating the microwave without food
- ■ Microwave popcorn
- Caution!
- Your new appliance
- Your accessories
- Before using the appliance for the first time
- Setting the language
- Setting the clock
- Heating up the cooking compartment
- Cleaning the accessories
- Switching the appliance on and off
- Operating the appliance
- Setting the operating mode and temperature
- MicroCombi, gentle / MicroCombi, intensive
- Heating indicator
- •
- œ
- The microwave
- Notes
- Notes regarding ovenware
- Microwave power settings
- Setting the microwave
- 1. Press the operating mode selector.
- Combination
- Suitable operating modes
- Suitable microwave power settings
- Setting a combination
- 1. Turn the operating mode selector until % Top/bottom heat appears on the text display.
- 2. Set the temperature selector to 200 °C.
- 3. Press the button for the microwave power setting you require.
- 4. Set the cooking time using the rotary selector.
- 5. Press the ƒ button.
- The cooking time has elapsed
- Changing the temperature or grill setting
- Changing the microwave power setting
- Opening the oven door during cooking
- Pausing operation
- Cancelling operation
- 1. Turn the operating mode selector until % Top/bottom heat appears on the text display.
- Series of operations
- Can be used with:
- Ovenware
- Setting a series of operations
- 1. Press the °±² button.
- 2. Set the first microwave power setting and cooking time.
- 3. Press the °±² button again.
- 4. Set the second microwave power setting and cooking time.
- 5. Press the °±² button again.
- 6. Set the third microwave power setting and cooking time.
- 7. Press the ƒ button.
- Checking the total or remaining cooking time
- The cooking time has elapsed
- Opening the oven door during cooking
- Changing the setting
- 1. Press the °±² button.
- Memory
- Electronic clock
- Clock display
- Minute minder
- Cooking time
- End of operation
- Preset operation
- 1. Set the operating mode and temperature.
- 2. Press the clock function button à repeatedly until the KJ and x symbols light up.
- 3. Set the cooking time using the rotary selector (e.g. ‚:„‹ hours).
- 4. Press the clock function button à repeatedly until the KJ and y symbols light up.
- 5. Set the end of operation using the rotary selector (e.g. ‚ƒ:„‹).
- 6. Press the ƒ button.
- The appliance waits until the appropriate time to switch on (in the example shown, ‚‚:‹‹).
- Setting the clock
- Childproof lock
- Lock
- Locking the appliance
- 1. Press the operating mode selector.
- Permanent lock
- Locking the appliance permanently
- 1. Press the operating mode selector.
- 1. Press the operating mode selector.
- 2. Press and hold the ± Info button until ™ƒ‚ appears on the temperature display.
- 3. Turn the temperature selector until ™ƒ‹ appears on the temperature display.
- 4. Press and hold the ± Info button until the ‚ symbol goes out.
- 5. Switch the appliance on within 30 seconds.
- Unlocking the appliance permanently
- 1. Press the operating mode selector.
- 2. Press and hold the ± Info button until ™ƒ‚ appears on the temperature display.
- 3. Turn the temperature selector until ™ƒ‹ appears on the temperature display.
- 4. Press and hold the ± Info button until the ‚ symbol goes out.
- 5. Within 30 seconds, press and hold the ± Info button again for a few seconds.
- 6. Turn the temperature selector until ™‚‹ appears on the temperature display.
- 7. Press and hold the Info button ±.
- Automatic safety cut-out
- Lock
- Auto start
- Basic settings
- Care and cleaning
- Notes
- Cleaning agents
- Cleaning the glass cover
- Removal
- 1. Place a tea towel in the oven.
- 2. Pull the clip on the oven ceiling forwards. (Fig. A) Press the front of the glass cover down using the thumb of your other hand. Let go of the clip.
- 3. Slide the cover forwards using both hands and rest it on the grill element. (Fig. B)
- 4. Slide it slightly backwards again. (Fig. C)
- 5. Tilt down at the side and remove. (Fig. D)
- Refitting
- Removal
- Cleaning the glass panels
- Faults and repairs
- Malfunction table
- Error messages with E
- Replacing the oven light bulb
- Note
- Method
- 1. Switch off the circuit breaker in the fuse box.
- 2. Place a tea towel in the cold oven to prevent damage.
- 3. Remove the glass cover. To do this, open the glass cover at the bottom with your hand. Should you experience difficulties removing the glass cover, use a spoon to help. (Fig. A).
- 4. Remove the bulb and replace with a bulb of the same type. (Fig. B).
- 5. Refit the glass cover. (Fig. C).
- 6. Remove the tea towel.
- 7. Switch the circuit breaker in the fuse box back on or plug in the mains plug.
- Replacing the door seal
- Malfunction table
- After-sales service
- Energy and environment tips
- Automatic programmes
- Ovenware
- Selecting a programme
- 1. Pop out the operating mode selector.
- 2. Press the X button.
- The first programme group appears.
- 3. Select the desired programme group using the operating mode selector.
- 4. Press the  button.
- 5. Turn the operating mode selector until the matching programme appears.
- 6. Using the temperature selector, set the weight of the food. The program length x is shown on the clock display.
- 7. Press the ƒ button.
- Note
- The programme has ended
- Cancelling the programme
- Calling up information
- Setting a later end time
- 1. Pop out the operating mode selector.
- Adjusting individually
- Defrosting and cooking with the automatic programmes
- Cooking
- Potatoes
- Cereal products
- Bake
- Frozen products
- Poultry
- Meat
- Fish
- Meat loaf and stew
- Tested for you in our cooking studio
- Slow cooking
- Using low-temperature cooking
- 1. Use ovenware with a properly fitting, matching lid, e.g. a glass roasting dish. Place the roasting dish on the wire rack.
- 2. Select / low-temperature cooking and a temperature between 70 and 100 °C. Preheat the cooking compartment, thus warming the ovenware at the same time.
- 3. Remove fat and sinews from the meat.
- 4. Sear the meat on all sides to seal it and to create a roasted flavour.
- 5. When a signal sounds and “In operation” appears in the text display, place the meat on the glass or porcelain plate in the cooking compartment.
- 6. Take out the meat at the end of the cooking time and switch off the appliance.
- Note
- Notes
- Slow cooking
- Tips for slow cooking
- Using low-temperature cooking
- Test dishes
- : Important safety information