Neff C67M70N3GB - Manual (Page 13)

13
Combination
This involves the simultaneous operation of another operating
mode with the microwave. Using the microwave makes your
meals ready more quickly, and still browns them nicely.
You can set a cooking time of up to 1 hour 30 minutes.
In this section, you can read about
■
which operating modes and microwave power settings are
suitable
■
how to set combination mode
Suitable operating modes
■
3 Hot air
■
2 Hot air plus
■
% Top/bottom heat
■
4 Circo-roasting
■
+ Full-surface grill
■
( Grill, small
Note: Rapid heat up cannot be switched on in combination
mode.
Suitable microwave power settings
All microwave power settings, except for 900 watts, can be
combined with an operating mode.
Setting a combination
Example: microwave 360 W, 17 minutes and % Top/bottom
heat 200 °C.
1. Turn the operating mode selector until % Top/bottom heat
appears on the text display.
The temperature display suggests 180 °C.
2. Set the temperature selector to 200 °C.
3. Press the button for the microwave power setting you require.
The clock display shows
‚† : ‹‹ mins and the x symbol.
4. Set the cooking time using the rotary selector.
5. Press the ƒ button.
Appliance operation begins. The cooking time starts counting
down.
The cooking time has elapsed
A signal sounds. Combination operation has finished. You can
stop the audible signal by pressing the à button. Switch off or
reset the appliance.
Changing the temperature or grill setting
This can be done at any time. Turn the rotary selector to
change the temperature or grill setting.
Changing the microwave power setting
Press the button for the new microwave power setting. Use the
rotary selector to set the cooking time and restart.
Opening the oven door during cooking
Operation is suspended.
ƒ flashes. After closing the door,
press the ƒ button. The programme will then continue.
Pausing operation
Press the
„ button briefly. ƒ flashes. The oven is paused.
Press the ƒ button again, operation continues.
Cancelling operation
Press the
„ button twice, or press and hold the „ button, and
switch off using the operating mode selector.
Note: If you also enter an end time, the operation which you
have set will switch on and off automatically. See the section
Electronic clock.
Series of operations
You can use the SeriesOperations function to set up to three
operating modes and then start.
Requirement: you must set a cooking time for each step.
Can be used with:
■
all microwave power settings
■
combination mode
Ovenware
Always use microwave-safe, heat-resistant ovenware.
Setting a series of operations
Requirement: the operating mode selector must not be pushed
in.
1. Press the °±² button.
The ° for the first operation in the series lights up.
2. Set the first microwave power setting and cooking time.
3. Press the °±² button again.
The ± for the second operation in the series lights up.
4. Set the second microwave power setting and cooking time.
5. Press the °±² button again.
The ² lights up for the third operation in the series.
6. Set the third microwave power setting and cooking time.
7. Press the ƒ button.
Appliance operation begins. The clock display shows the
cooking time of the first operation in the series. The ° for the
first operation in the series lights up.
Checking the total or remaining cooking time
Press the clock function button
à twice to display the
remaining cooking time.
The cooking time has elapsed
A signal sounds. The series of operations is finished. To stop
the signal, press the „ button. Switch off or reset the
appliance.
Opening the oven door during cooking
Operation is suspended.
ƒ flashes. After closing the door,
press the ƒ button. The programme will then continue.
Changing the setting
Changes can only be made before operation begins. Press
the °±² button to go to the desired setting, and make the
changes.
Note: You can also combine an operating mode with the
SeriesOperations function. First, set the oven operating mode.