Neff C67M70N3GB - Manual (Page 22)

22
Automatic programmes
The automatic programmes enable you to prepare food very
easily. You select the programme and enter the weight of your
food. The automatic programme makes the optimum setting.
Ovenware
The automatic programmes are only intended for roasting in
ovenware with a lid. For all programmes, use deep ovenware
with lid. Place the ovenware on the wire rack at level 1.
Suitable cookware
Heat-resistant (up to 300 °C) glass or glass ceramic ovenware,
for example, is suitable.
Unsuitable cookware
Cookware made of unglazed clay and plastic cookware or
cookware with plastic handles is not suitable.
Metal cookware is not suitable.
The microwave is used for some programmes. Metal does not
allow microwaves to pass through. The food will not brown as
much and the meat will not be as well cooked.
Size of the ovenware
The meat should cover about two thirds of the ovenware base.
This will ensure that you get good meat juices.
The distance between the meat and the lid must be at least
3 cm. The meat may expand during the roasting process.
Selecting a programme
Example in picture:
selecting and setting the programme for 0.30 kg of polenta.
1. Pop out the operating mode selector.
The appliance is ready for operation.
2. Press the X button.
The first programme group appears.
3. Select the desired programme group using the operating
mode selector.
4. Press the  button.
The first programme in the programme group appears on the
text display.
5. Turn the operating mode selector until the matching
programme appears.
6. Using the temperature selector, set the weight of the food.
The program length x is shown on the clock display.
7. Press the ƒ button.
The programme starts.
Note: After starting: press the ± button once. The set values are
shown on the displays.
The programme has ended
A signal sounds. The oven stops heating. Use the operating
mode selector to switch off the oven or select a new operating
mode and make the settings.
Cancelling the programme
Switch off the oven using the
„ button, turn the operating
mode selector to the Û position and push in.
Calling up information
Before starting: Press the button
± briefly. Various information
on the programmes is displayed. For each item of information,
press the ± button again briefly.
Setting a later end time
See the section Electronic clock.
Adjusting individually
If the cooking result of a programme does not meet your
expectations, you can change it the next time.
Make the settings as described in steps 1 to 5.
Press the
 button and use the operating mode selector to
move the illuminated square.
- ЩЩЩШЩЩЩ +
To the left = cooking result less well done.
To the right = cooking result more well done.
Start with the ƒ button.
The cooking time changes.
Defrosting and cooking with the automatic
programmes
Notes
■
Take the food out of its packaging and weigh it. If it is not
possible to enter the exact weight, you should round it up or
down.
■
Always use microwaveable ovenware, e.g. made of glass,
ceramic or the universal pan. Observe the accessories tips in
the programme table.
■
Place the food in the cold cooking compartment.
■
A table of suitable types of food with appropriate weight
ranges and the accessories required can be found in the sec-
tion after the tips.
3
'HIURVW
3
&HUHDOSURGXFWV
3
&HUHDOSURGXFWV
3ROHQWD