Neff C67P70N3GB - Manual (Page 13)

13
Changing the microwave power setting
Press the button for the new microwave power setting. Use the
rotary selector to set the cooking time and restart.
Opening the oven door during cooking
Operation is suspended.
ƒ flashes. After closing the door,
press the ƒ button. The programme will then continue.
Pausing operation
Press the
„ button briefly. ƒ flashes. The oven is paused.
Press the ƒ button again, operation continues.
Cancelling operation
Press the
„ button twice, or press and hold the „ button, until
the “Appliance is ready for use” heading appears. You can now
change the settings.
Note: If you open the appliance door during cooking, the fan
may continue to run.
Combination
This involves the simultaneous operation of another operating
mode with the microwave. Using the microwave makes your
meals ready more quickly, and still browns them nicely.
You can set a cooking time of up to 1 hour 30 minutes.
In this section, you can read about
■
which operating modes and microwave power settings are
suitable
■
how to set combination mode
Suitable operating modes
■
3 Hot air
■
2 Hot air plus
■
% Top/bottom heat
■
4 Circo-roasting
■
+ Full-surface grill
■
( Grill, small
Note: Rapid heat up cannot be switched on in combination
mode.
Suitable microwave power settings
All microwave power settings, except for 1000 watts, can be
combined with an operating mode.
Setting a combination
Example: microwave 360 W, 17 minutes and % Top/bottom
heat 200 °C.
1. Turn the operating mode selector until % Top/bottom heat
appears on the text display.
The temperature display suggests 180 °C.
2. Set the temperature selector to 200 °C.
3. Press the button for the microwave power setting you require.
The clock display shows
‚† : ‹‹ mins and the x symbol.
4. Set the cooking time using the rotary selector.
5. Press the ƒ button.
Appliance operation begins. The cooking time starts counting
down.
The cooking time has elapsed
A signal sounds. Combination operation has finished. You can
stop the audible signal by pressing the à button. Switch off or
reset the appliance.
Changing the temperature or grill setting
This can be done at any time. Turn the rotary selector to
change the temperature or grill setting.
Changing the microwave power setting
Press the button for the new microwave power setting. Use the
rotary selector to set the cooking time and restart.
Opening the oven door during cooking
Operation is suspended.
ƒ flashes. After closing the door,
press the ƒ button. The programme will then continue.
Pausing operation
Press the
„ button briefly. ƒ flashes. The oven is paused.
Press the ƒ button again, operation continues.
Cancelling operation
Press the
„ button twice, or press and hold the „ button, and
switch off using the operating mode selector.
Note: If you also enter an end time, the operation which you
have set will switch on and off automatically. See the section
Electronic clock.
Series of operations
You can use the SeriesOperations function to set up to three
operating modes and then start.
Requirement: you must set a cooking time for each step.
Can be used with:
■
all microwave power settings
■
combination mode
Ovenware
Always use microwave-safe, heat-resistant ovenware.
Setting a series of operations
Requirement: the operating mode selector must not be pushed
in.
1. Press the °±² button.
The ° for the first operation in the series lights up.
2. Set the first microwave power setting and cooking time.
3. Press the °±² button again.
The ± for the second operation in the series lights up.
4. Set the second microwave power setting and cooking time.
5. Press the °±² button again.
The ² lights up for the third operation in the series.