Nokia N93 - Manual (Page 101)

Tools
100
Call settings
Send my caller ID —Select Yes or No to set your phone to be
seen or hidden from the person you are calling. Otherwise,
the value may be set by your service provider when you
subscribe to the network service.
Set by network is displayed.
Call waiting —If you have activated call waiting (network
service), the network notifies you of a new incoming call
while you have a call in progress. To check whether the
function is active, select
Check status . To set the function
on or off, select Activate or Cancel .
Reject call with SMS —Select Yes to send a text message
to a caller informing why you could not answer the call.
See "Answer or decline a call", p. 60.
Message text —Write a text to be sent in a text message
when you reject a call.
Image in video call —You can deny video sending when
you receive a video call. Select a still image to be displayed
instead of video.
Automatic redial —Select On , and your device makes a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
Summary after call —Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
1-touch dialing —Select On , and the numbers assigned to the
1-touch dialing keys ( - ) can be dialed by pressing and
holding the key. See also "1-touch dialing", p. 55.
Anykey answer —Select On . To answer an incoming call,
briefly press any keypad key except , , , and .
Line in use —This setting (network service) is shown only if
the SIM card supports two subscriber numbers, that is, two
phone lines. Select which phone line you want to use for
making calls and sending text messages. Calls on both lines
can be answered irrespective of the selected line. If you select
Line 2 and have not subscribed to this network service, you
will not be able to make calls. When line 2 is selected,
is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold
in the standby mode.
Line change —To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Connection
Data connections and access points
Your device supports packet data connections, such as
GPRS in the GSM network. When you use your device in
GSM and UMTS networks, multiple data connections can
be active at the same time, and access points can share a
data connection.