Nokia N91 - Manual (Page 96)

Tools
95
Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name —Select Enter manually or Search for
netw. . If you select an existing network, WLAN netw. mode
and WLAN security mode are determined by the settings
of its access point device.
WLAN netw. mode —Select Ad-hoc to create an ad-hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode —Select the encryption used: WEP ,
802.1x (not for ad hoc networks), or WPA/WPA2 . If you
select Open network , no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security sett. —Enter the settings for the selected
security mode:
Security settings for WEP :
Wep key in use —Select the WEP key number. You can create
up to four WEP keys. The same settings must be entered on
the wireless LAN access point device.
Authentication type —Select Open or Shared for the
authentication type between your device and the wireless
LAN access point device.
WEP key settings —Enter WEP encryption (length of the
key), WEP key format ( ASCII or Hexadecimal ), and WEP
key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2 :
WPA mode —Select the means of authentication: EAP
to use an extensible authentication protocol (EAP) plug-in,
or
Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP )—Enter the settings
as your service provider instructs.
Pre-shared key (only for Pre-shared key )—Enter a password.
The same password must be entered on the wireless LAN
access point device.
TKIP encryption —Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage —Define a home page.
Select Options > Advanced settings and from the
following:
IPv4 settings : Phone IP address (the IP address of your
device), Subnet mask (the subnet IP address), Default
gateway (the gateway), and DNS address —enter the
IP addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings > DNS address —Select Automatic ,
Well-known , or User defined .
Ad-hoc channel (only for Ad-hoc )—To enter a channel
number (1-11) manually, select User defined .
Proxy serv. address —Enter the address for the proxy server.
Proxy port number —Enter the proxy port number.