Nokia N91 - Manual (Page 60)

Messaging
59
Access point in use —Select which access point is used as
the preferred connection for the multimedia message center.
Multimedia retrieval —Select how you want to receive
multimedia messages. To receive multimedia messages
automatically in your home network, select
Aut. in
home network . Outside your home network, you receive
a notification that there is multimedia message that you
can retrieve in the multimedia message center.
When you are outside your home network, sending and
receiving multimedia messages may cost you more.
If you select Multimedia retrieval > Always automatic ,
your device automatically makes an active packet data
connection to retrieve the message both in and outside
your home network.
Allow anon. msgs. —Select whether you want to decline
messages from an anonymous sender.
Receive ads —Define whether you want to receive
multimedia message advertisements.
Receive report —Select whether you want the status of the
sent message to be shown in the log (network service).
Receiving a delivery report of a multimedia message that
has been sent to an e-mail address may not be possible.
Deny report sending —Select whether you want to deny
your device sending delivery reports of received
multimedia messages.
Message validity —Select how long the message center
resends your message if the first attempt fails (network
service). If the recipient cannot be reached within the validity
period, the message is deleted from the message center.
Tip! You may also obtain the multimedia and e-mail
settings from your service provider in a configuration
message. Contact your service provider for more
information. See “Data and settings,” p. 54.
E-mail
Press , and select Messag. > Options > Settings >
E-mail and from the following:
Mailboxes —Select a mailbox to change the following
settings: Connection settings , User settings , Retrieval
settings , and Automatic retrieval .
Mailbox in use — Select which mailbox you want to use
for sending e-mail.
To create a new mailbox, select Options > New mailbox
in the mailbox main view.
Connection settings
To edit the settings for the e-mail you receive, select
Incoming e-mail and from the following:
User name —Enter your user name, given to you by
your service provider.
Password —Enter your password. If you leave this field
blank, you are prompted for the password when you
try to connect to your remote mailbox.